Magnetic Suspension Centrifugal Blower Wholesale Price tells: How to do the waterproof of centrifugal fan?

[Abstract]:
A section of drainage port should be reserved at the top of the fan. The location of the drainage port is about 15 cm to 20 cm. The lower end of the wave crest opening should be plugged. The bottom of the wave crest must not be left out of the drain, but it needs to be tightly attached to the base.

We know that the application range of centrifugal fans is very wide, so the use environment of the equipment is more complicated and may be exposed to various environments. However, the equipment itself is an electrical equipment. In order to ensure the normal operation of the use process, there are many conditions for use. Limitations, which require waterproofing, if the equipment is not waterproof, it will cause a lot of problems such as leakage and corrosion. So how to do a good job of waterproofing during use? Follow the editor of Magnetic Suspension Centrifugal Blower Wholesale Price to have a brief look!


1. A section of drainage port should be reserved at the top of the fan. The location of the drainage port is about 15 cm to 20 cm. The lower end of the wave crest opening should be properly plugged. The bottom of the wave crest must not be left out of the drain, but it needs to be tightly attached to the base.
2. There should be a flashing plate around the base of the centrifugal fan. When the flashing plate is fixed, blind rivets can be used. The diameter of the rivet is 5mm, and the density is about 10 cm. When fixing with rivets, it must be fixed firmly and not loose. The surroundings of the flashing board should be flat, and there should be no corners, let alone collapse. The surrounding flashing plate should be higher than the outer part at the side of the base, so as to prevent water accumulation in the fan in the future.
3. There should be no large areas of rust spots around the fan base.
The above is the editor of Magnetic Suspension Centrifugal Blower Wholesale Price telling: about the waterproof knowledge of centrifugal fans.

New Application of TB Turbo Vacuum Pump in Paper Mill
$!info.title
In the process of paper making, vacuum technology is mainly used for vacuum dewatering of paper machine. At present, most of the vacuum equipment in paper mill are liquid ring vacuum pumps with high energy consumption, low efficiency and pollution of water resources, which is difficult to meet the energy-saving and emission reduction goals proposed by the government.
Typical Application of Roots Blower in MAERZ Lime Kiln
$!info.title
MAERZ Lime Kiln (also called Co-Current Heat Accumulated Kiln with Double Shafts) is developed by a Switzerland company named MAERZ OFENBAU AG and awarded the technology patent in 1965. This company is the leading engineering company providing patented technology Lime Kiln used for producing high quality Lime and Dolomite. More than 500 units Lime Kilns have been established in more than 50 countries all over the world.
Typical Application of Blower in FGD of Power Plant
$!info.title
Desulphurization of power plant refers to a process that to remove sulfur oxides (SO2 and SO3) from Flue Gas or other industrial waste gas.  
Shandong Zhanggu - Shanghai Lymax Leading technology in coking waster water field
$!info.title
We are a creditable public company with over 50 years of history on researching and producing blowers, and have become one of the most important blower manufacturers in the world.
Shandong Zhangqiu Blower Co., Ltd. - Environmental Protection Development
$!info.title
We are a creditable public company with over 50 years of history on researching and producing blowers, and have become one of the most important blower manufacturers in the world.
Page up
1
2
3
4
5
6
7
8
9
...
14
zhanggu