Disassembly method of Roots Vacuum Pump supplier china
Do you know the disassembly method of Roots Vacuum Pump supplier china? Let's take a simple look below!
1. Before disassembling, Roots Vacuum Pump supplier china measure and record the clearance of each part of the rotor.
2. Try to avoid hitting with a heavy hammer, and the removed parts must not be bruised and kept properly.
3. Record the reasons for replacement and usage of the parts to be replaced in detail.
4. Roots Vacuum Pump supplier china must clean all parts and burrs before reassembly.
5. Use "106" silicone rubber coating on the static sealing surface without sealing gasket or sealing ring. Use clean sealing rubber seals, apply vacuum cork grease. The sealing ring and the surface of the relief valve of the vacuum pump with relief valve shall not be coated with any Ke grease.
6. Adjust the clearance of each part of the rotor according to the clearance list.
7. After all installed, it must be checked for leaks.
8. Trial operation and necessary performance tests must be carried out after reinstallation, and can only be installed and used after normal operation.
The above is a brief introduction to the relevant knowledge about the disassembly method of Roots Vacuum Pump supplier china.