NEWS CENTER


Listening to cutting-edge information, focusing on the dynamics of zhang drums

Low price Ceramic Slurry Pump introduces the knowledge of the selection of the cylinder liner material of the mud pump

Some important parts of mud pumps are difficult to maintain, and cylinder liners are especially important. Because the working surface of the cylinder liner is in contact with high-temperature and high-pressure gas, there is a piston ring that reciprocates at high speed on its surface. This determines that the cylinder liner must not only have sufficient strength and rigidity, but also need high temperature resistance, corrosion resistance, and wear resistance. damage.

A brief introduction to the basic knowledge of Liquid Ring Vacuum Pump manufacturers

A Liquid Ring Vacuum Pump manufacturers, the two exhaust ports of the pump body are respectively connected to the two inlets at the lower part of the gas-water separator through pipelines, and the two intake ports are used to connect to the gas pipeline to be pumped;

How much do you know about customized Liquid Ring Vacuum Pump

The new customized Liquid Ring Vacuum Pump involves the technical field of vacuum pumps, including the pump body, the impeller located inside the pump body, the front disc fixed at the front end of the pump body, and the rear disc fixed at the rear end of the pump body. The side disc is provided with an air inlet and an air outlet.

Precautions for the selection of Liquid Ring Vacuum Pump Wholesale Price

The working pressure of Liquid Ring Vacuum Pump Wholesale Price should meet the ultimate vacuum and working pressure requirements of vacuum equipment.

Liquid Ring Vacuum Pump Wholesale Price Reasons for High Motor Temperature

The voltage of the busbar where the Liquid Ring Vacuum Pump Wholesale Price is located is 380V. Due to the cable voltage drop and uneven load distribution, the actual voltage applied to the motor is only 365V, and the low voltage causes a large operating current.

The basic principle of SSR Roots Blower from China manufacturer

SSR Roots Blower from China manufacturer is a volumetric blower. It relies on the change of the volume of the working chamber formed by the rotation of two involute "8" rotors to transport gas. Its working principle is the same as that of a gear pump. The same, i.e. each rotor is equivalent to a gear with only two teeth.

< 1...171819...24 > 跳转到

We use optional cookies to improve your experience on our website, including through social media connections, and to deliver personalized advertising based on your online activity. If you decline an optional cookie, we will only use cookies that are necessary to serve you.